Customer Questions and Answers for Dishwasher Detergent Dispenser Assembly by Bosch

Jim, It's not hard at all,To remove outer door: ??Remove six T-20 Torx inner door screws below fascia panel --three per side (1). ??Carefully pull bottom of outer door out from dishwasher until top door tabs clear, then pull door down until it releases from dishwasher (2). Take care to not scratch outer door.??Remove two plastic door guards (3). They occasionally fall out when the outer door is removed. To remove/install dispensers: ??Remove outer door, remove fascia panel & disconnect wire harness from fascia panel. ??Disconnect wire harness from above dispenser, then remove wires to wax motor & reed switch. ??Disconnect condensation tube (for older models with condensationtubes in doors). ??Bend retainer tabs, the push dispenser inward toward tank. Protect hand with towel as edges are sharp. ??Replace from inside of tank --position O-ring seal and bend tabs to secure. When replacing dispensers, lubricate O-rings with rinse-aid & support inner doors to avoid damage if O-rings stick. I'm sure you can do it, Good Luck.

Hello Jim! I have located a link on our free repair forum that explains how to install 00263088. Hope it helps! http://forum.appliancepartspros.com/dishwasher-repair/5658-how-replace-soap-dispenser-bosch-dishwaser.html