Customer Questions and Answers for Dispenser Assembly by Bosch

Hello Cindy. Here are the instructions from the manufacture on how to install the dispenser. Hope this helps. To remove/install dispensers: ??Remove outer door, remove fascia panel & disconnect wire harnessfrom fascia panel. ??Disconnect wire harness from above dispenser, then remove wires to wax motor & reed switch. ??Disconnect condensation tube (for older models with condensationtubes in doors). ??Bend retainer tabs, the push dispenser inward toward tank. Protect hand with towel as edges are sharp. ??Replace from inside of tank --position O-ring seal and bend tabs to secure. When replacing dispensers, lubricate O-rings with rinse-aid & support inner doors to avoid damage if O-rings stick.