Badwasher for Model Number GLTF2940FS2 My washer goes through all the steps but stops at spin. This behavior is intermittent. I get the error code E43. The data sheet has a test (no. 7) and the diagnosis from that test points to control board sometimes and the door lock switch sometimes - not the same result every time. I replaced the door lock switch, didn't help. I also replaced the control board - the spin works, but other functions are messed up - e-g "pause/cancel" starts the wash cycle instead of "start" and the wash cycle choices (delicate/drain and spin/quick .. etc) are not sensed correctly. When I put back the original control board, everything worked fine for a few days, but back to the same no-spin problem. Can you please tell me what to do next ?
Answer BadWasher, Recheck the J3 and J2 harness and wires between the control board and door latch assembly. If all's Ok reorder another control board 137006000 and handle it carefully. It sounds like you received a defective or mispackaged part previously. Read More... Answered by AppliancePartsPros.com | Tuesday, September 16, 2014