Doug for Model Number GLTF2940ES1 Washer was completely dead. Being an electronics tech, I dove into the control board. Checked a few things, manually fired the relays with a 12v supply, and reassembled it. To my surprise is worked! well not really. It won't pump. No power at the pump when trying to start the drain/spin. In diagnostic mode, when I turn it to the pump/spin (8th or 9th click on the dial), it immediately exits diagnostic mode. Only error was E14 because the reed switch wasn't plugged in the first time I tried to run it.
Answer Hi Doug. Do You have any fault codes? Take the air dome hose off the pressure switch and blow into the tub area. Is there any restrictions. Lint or debris will build up and "mis-read" the switch. You can use "Affresh Washer Tablets" monthly to help keep it clean,part # is W10501250. The pressure switch has to be satisfied in order to allow hi-speed spin. This part # is 134762000. Thank you. Read More... Answered by AppliancePartsPros.com | Friday, September 9, 2011