Matt for Model Number GLTF2940ES3 Frigidaire washer bought 2007. Got an error code that suggested main control board was at fault, so replaced it with one bought from you. Didn't fix problem and got a different error code, which led to replacing speed control board, also bought from you. Now the washer works but the cycles and controls are out of whack. All the cycles we've tried work, but most don't do what we expect. For example, the "normal" cycle used to take 52 minutes. When I set the dial to "normal" now, the display shows 28 minutes. The "heavy" cycle used to take 56 minutes; now the display shows 52 minutes. Did they rearrange the dial labels and buttons between 2007 and now? If so, is there a chart we can use to translate new dial labels to old dial labels? Or is this a common failure suggesting that the new main control board is defective? Our laundry room is tiny, and we've got the dryer stacked on top of the washer, so it's a big hassle to get at the control board. Otherwise I'd swap the old one back in and see what happened.
Answer Matt, It sounds like the unit control board may be faulty but would suggest to put the unit into diagnostic and see if it corrects the issue and if it does not then this will be a bad control board. Read More... Answered by AppliancePartsPros.com | Monday, March 19, 2018