Cliff for Model Number GLTF2940EE0 Circuit breaker tripped at end of cycle, reset, turned on again, tripped, reset, turned on third time. Error code "do" and E14, can't enter diagnostic mode. Removed front control panel, component blown next to the blue connector and component on right side - impressive black residue on board and front cover! Was it an internal failure, or a dead short in the motor or some other component? I'd rather not install a new board and then blow it up, too. Thanks for any suggestions you might have.
Answer Cliff, The "DO" and E14 display would indicate an issue in the door lock assembly, You need to check the wiring and the door lock/switch assembly, before you replace the other damaged parts, Thanks and Good Luck Read More... Answered by AppliancePartsPros.com | Wednesday, February 8, 2012