Angela for Model Number LTF2940FS1 When start is activated the machine lights behave normally and the door locks but no water flows. After a few seconds most of the lights go out except for the door lock, start and no spin lights up. After a few more seconds all the lights go out and the door unlocks. When the start button is activated again, Err appears in the display. E23 displays when the error code is recalled. The manual says to replace console control board, wire or pump. Any suggestions on which to start with? Also is there any instructions to replace the parts? Thank you.
Answer Hi Angela. Shut off the water supply valves. Put the hoses one at a time in a bucket and flush them out verifying a strong water flow in each hose. Inside the unit water valve4 are filter screens. Make sure they are not blocked. Flush them out. Then Remove the front lower panel. Use towels and a wet shop vac to pick up water. Remove the pump - to - tub hose (sump Hose). Clear it as well as the inside of the tub where it connected to the hose. Remove the drain hose from the pump. Clean the pump and if the impeller is damaged or loose on the pump shaft, replace the pump w/part # 137221600. F-24 code is found in the supplied tech sheet under the top in a packet. it say to trace the temp. sensor ( thermistor) for 12k ohms. Make sure all connections are tight. Thank you. Read More... Answered by AppliancePartsPros.com | Thursday, September 20, 2012