Selfrepair for Model Number LTF2940FE1 LTF2940FE1 stopped mid-load full of water. Unit is several years old. Unplugged for a while, then powered up. Starts cycle, but as soon as cycle tries to start, the Spin light (High Spin) goes to No Spin and nothing further happens. I cleaned out the drain hose and filter, but no change in behavior (wasn't clogged very much). Also, when starting the cycle, no water starts. So I'm not sure if it's a control board, valve, or drain pump. Can you tell me how to run a diagnostic (if it's possible)? It would be nice to isolate the problem and not buy a bunch of replacement parts just "shooting in the dark." Thank you!
Answer SelfRepair, You should find the Technical Data Information and Wiring Diagram sheets, attached to the interior left side cabinet panel, once you remove the lower front access panel. If you follow the instructions, you'll be able to test all the washer components, and review all the diagnostic/failure codes that have been acumulated over time. Read More... Answered by AppliancePartsPros.com | Friday, December 21, 2012