Curt for Model Number 79046572400 I have this Kenmore range that had no lights on the the display but burners worked, did research and it pointed to control being suspect. ordered control and installed and am having same problem, so I checked breaker and am getting 120 volts on each side of breaker getting 240 across checked power block and am getting 240 volts on one side and nothing on other and nothing across power block is not damaged. at outlet am getting 120 volt on one side and 108 volts on other and 248 volts across both. I am puzzled by this. As always I appreciate all your help.
Answer Hello, Curt. You need to check the thermal cut off thermostat p/n AP3211049 for continuity. According to the diagram it should have two violet wires coming to it. You can test it from the control board large disconnect plug between the two violet wires. This thermostat could be located under the cooktop or at the back of the oven, behind the rear panel. If there is no continuity - replace the thermostat. You may check the oven by placing a TEMPORARY jumper on the two terminals of the cut off thermostat. Good luck. Read More... Answered by AppliancePartsPros.com | Tuesday, June 2, 2020