Jim M. for Model Number 41729042991 The machine cycles through all the phases but the length of time went from about an hour to more than one and a half hours. I replaced the timer with a new one but the length of time to complete the wash hasn't changed it's still 1 1/2 hrs. Do you have any suggestions as to what the cause could be. Thanks.
Answer Hi Jim. Immediately to the left of the timer is a speed control part # [131716900]. I would use a volt/ohm meter part # MA-DM1 to assist. you in your diagnosis. This may be either selected to a slower speed or internally shorted so it only works one speed. Open the bottom of the control panel. Use a shop vac to clean the water in the pump. The pump intake hose has a filter cup that catches the wash basket debris. Make sure that the pump impeller is solid on the shaft and not spinning loose. The pump has to drain completely then the spin speed will be met. Pump part # 137108000. Make sure the inlet valve screens are not clogged slowing the fill time. Flush out the hose's and screens also. Remove the top back 3-torx screws, push back on the top and lift up. Remove the 3/8" hose connected to the pressure switch and blow back in towards the tub. Did you remove any lint, debris or suds ? All will slow down production. Use Affresh tablets to insure the unit is cleaned monthly part # W10501250. Thank You. Read More... Answered by AppliancePartsPros.com | Tuesday, April 17, 2012