Vicky for Model Number Hotpoint CSX226GRBKAA We ordered ice maker WR30X10093, order # 7415899. Water was collecting under auger in ice bin preventing auger from turning. (We assumed the ice maker was leaking, thus ordered the new one.) After several attempts to install (we had to use the adapter plug which made it much more difficult than your video) we finally were ready to test it. We also adjusted the small wheel toward the minus sign. After hearing ice being dumped into the bin we opened the freezer door and noticed water dripping and freezing on left side of freezer wall and assumed it was splashing out of the round hole on the side of the new fill cup. We took the ice maker out again and covered the hole with metal tape as suggested in another post. Reinstalled ice maker and still have water freezing on the side wall. Please advise.
Answer Vicky, Check to see that the refrigerator level and then check the ice maker is level in both directions. Then recheck the fill time in a test mode, it should take 5 or 6 seconds to fill the heater mold properly, and check the fill spout and funnel to make sure the water isn't splashing or migrating from the funnel or spout. Read More... Answered by AppliancePartsPros.com | Thursday, March 2, 2017