Stan J. for Model Number GXRTQ The GXRTQR water filter once contained the connectors and the filter in the box. If the connectors are no longer in the box, where can a homeowner obtain the connectors? All John Guess fittings work the same way: John Guess Fitting Procedure: To remove: Push line in and hold ring in, then, while holding ring in, pull line out. To re-install, push line in until resistance is met. Push harder until line "pops" in another 1/4 inch or so. Pull on line without touching the ring to seat seal. The locking clip (when included) should then be installed under the ring to prevent the John Guess fittings from accidentally being released. Note that the part comes with an instruction sheet.
Answer Hello Stan, The new filter has John Guess fittings made on the filter. Simply Note the direction of water flow marked on the filter and cut the water line off squarely on each end to remove the old filter. Install the new filter in the same configuration. John Guess Fitting Procedure:To remove: Push line in and hold ring in, then, while holding ring in, pull line out.To re-install, push line in until resistance is met. Push harder until line "pops" in another 1/4 inch or so. Pull on line without touching the ring to seat seal.As a note, the output end of the filter should not be connected until the filter has been flushed as per the manufacturer. Read More... Answered by AppliancePartsPros.com | Monday, March 7, 2016