Customer Questions and Answers for Cooktop Selector Switch by Ge

Hello Vinesh B. 1. Remove all 7 knobs from the cooktop.
Note: Remove any knob clips that remain on the control
shafts and reinsert clips inside knob stems.
2. Remove 4 screws and the wiring access cover
located below the controls. Disconnect the white 5-
pin blower connector inside.
3. Remove 3 screws that hold the component plate to
the cooktop. The screws are above the wiring with 2
toward the front and 1 toward the rear. Caution: Save and replace with the exact screws to
prevent glass breakage (#8-18 x 1/4-in.).
4. Unplug the 2 red and 2 white connector housings.
5. Lower the control assembly and rotate the front side
down to remove. 6. Now you can access and replace the switch WB24X449. Hope this helps.