Harold for Model Number JGP-975 s/n 205c-2981-Pod-112 I have a JGP-975 Gas cooktop, built in. Where is the spark module located on the cooktop? You demo shows only for stoves not cooktops. The unit has been sealed to prevent food from going under the cover plate.
Answer Hello Harold. SPARK MODULE ACCESSAccess to the spark module varies depending upon the model numberof the product. Please check the name and number plate to identify themodel number prior to any disassembly.• Make sure that power is disconnected before servicing.• Remove all control knobs.• Remove all burner caps.For all cooktops with glass maintop:• Remove the screws securing the burner bases. Use a number 15 torx bitfor this removal.• Lift the burner bases up from the glass maintop and remove the sparkignition wire from each burner electrode.• Lift the cooktop from the burner box SPARK MODULE ACCESS (cont.)For cooktops with 15,000 BTU right front burner:• Remove right rear, left front and left rear burner bases by liftingfrom maintop.• Pull burner electrode up from maintop and remove spark ignition wire.• Remove three screws (from each burner) that hold the maintop to theburner spider. A number 15 torx bit is required.• Remove burner head from right front burner by pulling straight up fromburner base. (Note: this is a snug fit, so pull straight up).• Remove two screws that secure the burner base to the burner inlet.• Remove the burner base from the maintop. The maintop may now beremoved, exposing the spark module.For cooktops with 12,000 or 9,500 BTU right front burner:• Remove the burner bases by lifting from maintop.• Pull burner electrode up from maintop and remove spark ignition wire.• Remove three screws (from each burner) that hold the maintop to theburner spider. A number 15 torx bit is required.• Remove the maintop, exposing the spark module. Read More... Answered by AppliancePartsPros.com | Thursday, November 21, 2013