Bonnie for Model Number gld5800l00ww I have replaced the main board, keyboard control board (the green one), and the air diverter switch. When I turn on dishwasher, just have a constant "clean" blinking light. Looked at directions, said to hold down reset button, that's the only way the blinking will stop. The dishwasher won't run at all. It hasn't worked for four months, help! Do I need a switch?
Answer Hi. FLASHING DISPLAY LIGHTS :Status Indicator Lights What It Means...START/RESET Cycle has been interrupted by pressing the START/RESET START/RESET keypad. Light will quit ?ashing after keypad. Light will quit ?ashing after the dishwasher automatically drains out the water. Remove the drain hose at the sink connection. Use a screwdriver to see if it is clogged. Remove the drain hose at the pump and clear the hose. Also make sure the drain hose is clamped as far up under the sink using a loop and then taught to the sink connection. Make sure the drain pump part # WD26X22719 impeller is not spinning loose on the pump shaft. Thank You. Read More... Answered by AppliancePartsPros.com | Friday, October 19, 2012