Tim for Model Number DBXR453ET2WW Thanks so much for the quick response. 240 present at power cord terminal block. All the panel tests you listed are good. Since a timer plus element would push the parts cost higher than I'd like to spend on a repair, is it possible to jumper connections at the panel and power up to test for heating without taking the machine apart? If element (and/or thermostat) is bad I would likely just buy another dryer. Thank you again for your time.
Answer Tim, as the tests that were recommended were good, this would identify that voltage is able to pass through to the inlet thermostat. This would indicate that the inlet thermostat WE4M160 and the heating element WE11M23 would need to be tested directly as jumping out any connections would not result in any other testing outcome than what has already been tested through continuity checks. The thermostat would be tested for continuity while the heating element would be tested for resistance and should measure 19 Ohms on the inner coil and 19 Ohms on the outer coil. Read More... Answered by AppliancePartsPros.com | Tuesday, February 8, 2022