David for Model Number WBSR3140GOWW I checked the water valves. During the first part of the cycle, the water valves work fine (including the cold one). They have 120V going to them when they're open, so they don't seem to be the problem. After that first cycle, the timer just stops. So, I put my meter on the water valve again at that time and got no voltage. But, couldn't this be because the timer isn't sending out a signal? Or, could it be the water level switch functioning incorrectly? Thanks you SOOOO much for your help! Here's my previous questions: No, the temperature of the water does not matter at all. The same thing happens whether it's on cold or hot water for the first cycle. Thanks for your first answer. Any other ideas? Here's my original question: My washing machine stops mid cycle. It will do the first washing, completely drain, but then freezes and won't fill up again to do the rinse. If I advance the timer, it goes through the rest of the cycle (timer just makes noise for a while, then spins the tub to get the water out, even though it has no water in it). I've tried all the different cycles, and they all do the first washing, but as soon as it drains and tries to do the rinse, the timer stops. I think it may be the water level switch, but I'm not sure. Any ideas? Thanks for your help!
Answer Hello David. Based on the information you provided, it does sound like the timer WH12X10350 is bad and will need to be replaced. If the pressure switch WH12X10065 is bad, the unit should start agitating, and not just stop. Hope this helps. Read More... Answered by AppliancePartsPros.com | Thursday, August 4, 2011