Keith for Model Number wm2455HW Washer does not wash clean anymore. Clothes does not get wet enough. Been this way for months. Used to see water kind of running over the front bottom seal but now barely. No error codes. Removed the Air Chamber - no blockages. No air restriciton when blowing thru the inlet hose. Tried washer again - still same issue. Have replaced the pressure switch, removed and reseated the connectors at the main PCB board - still same issue. Have PDF manuel for trouble shooting this model but the washer is not broken enough to generate any error codes. Is there a factory reset that could possible resolve this problem or something else I can check just shy of replacing the Main PCB? Would appreciate any help. Thanks
Answer Hello Keith, You need to check the screens in the water valve and check for screens in the inlet hoses. If there are none or they are clear, it is most likely a water valve not allowing the water to enter the unit at full pressure. Read More... Answered by AppliancePartsPros.com | Friday, April 25, 2014