Seth for Model Number RF268ABRS/XAA-0000 I have a RF268ABRS refrigerator. The fridge and freezer stopped cooling at all. When I run the self diagnostics it flashes F10 B only. The compressor gets warm but does not seem to run. The evaporator tubes never get ice on them. I believe the inverter board is the problem. I checked the AC voltage coming into the board and have 120 volts. after the overloads I still have 120 volts. I do not see any power going to the compressor. I checked the ohms between all three wires going to the compressor 11 ohms was what my meter read. When I check dc voltage from CN76-1 CN75-4 I show 2.2 volts CN75-3 shows 0.0 volts CN75-2 shows 5 volts. If I check CN75-3 to CN75-4 I get 0 volts. Would this be the inverter board or do I need to look at something else?
Answer Seth, based on the information provided, either the main control DA41-00620C has failed or the thermistors are not sensing temperature properly. The main control would send 2.5VDC at CN75 pin 4, pin 3, and CN76 pin 4 when calling for cold air (using CN76 pin 1 as the DC ground). The thermistors would need to be tested for resistance and should measure 3344O at 37°F, 2997O at 40°F, 2627O at 44°F, 2309O at 48°F, and 2036O at 52°F. Read More... Answered by AppliancePartsPros.com | Monday, October 19, 2020