Customer Questions and Answers for Bellow Tub Seal by Whirlpool

Hello Felix, no video on this at this time but we are adding videos regularly. Until a video is available, here are the instructions. 1. Unplug washer or disconnect power. 2. Turn off the water supply to the washer. 3. Remove the top cover and the console. 4. Remove the lower front access panel. 5. Open the washer door. 6. Using a small screwdriver or a pair of long-nosed pliers, pull the tension spring on the retaining wire out from around the front of the bellows, and remove the wire. 8. To remove the bellows: a) Remove the two T-20 Torx screws from the door switch assembly. b) Remove the front panel from the washer. c) Turn the bellows retaining clamp screw counterclockwise until the clamp is loose enough to remove it from around the bellows. NOTE: It may be necessary to completely remove the screw from one end of the clamp. d) Remove the bellows retaining clamp from around the bellows WP8182119. e) Pull the bellows off the front of the tub. REASSEMBLY NOTE: When you reinstall the bellows, be sure to position the “weep holes”at the bottom, and align the top arrow mark at 12:00 first. Thanks!