Philipp for Model Number KFIS20XVMS2 I just replaced the main hv control board and now it needs to be programmed to the correct code on the serial plate but it didnt come with instructions on how to program it.
Answer Hello Philipp. Programming Mode:NOTE: The Program Code is located on the Serial Plate on this unit after the word Code.1. Press and hold the WATER Keypad.2. Press and hold LL Keypad.3. Release the WATER Keypad and wait 3 seconds.4. The control will display PE to indicate the programming mode.5. Entry is confirmed by pressing the LL Keypad once more.6. The control will display the current Program CODE. This value should be validated with the Program CODE printed on the unit serial plate.NOTE: If the Program CODE is correct, the Programming Mode is exited by pressing water Keypad for 3 seconds.7. Press the UR Keypad or LR Keypad to change the digit value with each key press.8. The decimal point indicates the selected digit. Press the UL Keypad to select the next digit.9. Once the desired Program CODE is entered, press and hold the LL Keypad until the Program CODE begins flashing indicating it has beensaved.NOTE: If you attempt to enter an invalid Program CODE the control will not save the new code, but will beep. (The unit will NOT run with aProgram CODE of 0000). Once the Program CODE has been saved the Programming Mode is exited by pressing any key or by opening orclosing the refrigerator door. If the new code is incorrect this process should be repeated.The Programming mode can be exited at any time by pressing WATER key for 3 seconds or will exit if unattended for four minutes. Read More... Answered by AppliancePartsPros.com | Friday, September 9, 2016