Robert for Model Number MFI2569VEM1 This model number is for a Maytag French door bottom freezer unit. My problem is that the ice dispensing worm drive motor does not stop when you are finished and will spew ice all over the floor. Similarly to other posts here, sometimes the motor will energize on its own, overfilling the "chute". The entire "chute" assembly was replaced and it did not correct the problem. Next, the main circuit board on the rear was replaced, twice, 28th separate replacement boards. Each replacement resulted in the same condition. The front control board displayed "PE0000. Nothing would function on the door control panel to allow the required programming which for my unit is code 2020. Ice reinserted my original board and all functions are back to normal except the malfunction as noted. What's my problem? Thanks
Answer Hello Robert, This is normally caused by a sticking switch on the chute assembly WP13005705. If this does not correct the issue, I would recommend checking the wiring harness where it passes through the door hinge for a possible shorted harness. Read More... Answered by AppliancePartsPros.com | Saturday, May 12, 2018