Dan for Model Number wfw9500tw01 Where is the motor control board located and what do you have to do to get to it ? Thx
Answer Dan, Your motor control board is located inside the lower left side bottom of the cabinet WP8183196 . Here's the procedure : "1. Unplug washer or disconnect power. 2. Turn off the water supply to the washer. 3. Pull the washer away from the wall. 4. Remove the four plastic shipping bolt hole covers. To remove a cover, lift the rounded end to unhook the locking tab from the slot in the chassis, and slide thecover off the rear panel. 5. Remove the hex-head screws from the rear panel. 6. Pull the bottom of the rear panel out, and slide it down so the top edge is out from behind the lip of the upper panel, and remove the rear panel. 7. Pull the hose out of the holders on top ofthe motor control unit. 8. Remove the wire ties from the cover. 9. Use a flat-blade screwdriver, and pry the locking tab up on the bottom of the motor control unit to release it, then slide the unit forward to release the four tabs from the keyhole slots, and lift the motor controlunit from the washer. 10. Disconnect the four wire connectors from the motor control unit and remove the unit." Good Luck, and Thanks Read More... Answered by AppliancePartsPros.com | Thursday, July 21, 2011