Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Motor Control Board by Whirlpool

4.89 (64)
By: Whirlpool
Part Number: OEM18035616
Manufacturer Part Number: WP8183196

This motor control board regulates the washer's drive motor, controlling spin speed and direction during wash and spin cycles. It is typically mounted near the bottom of the washer behind the front or rear access panel. Replace this board if the washer won't spin or agitate, stops mid-cycle, or if the motor runs erratically or not at all.

More
$279.22

IN STOCK
Ships Tomorrow Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Washer Motor Control Board (Part Number: OEM18035616)

View all Questions

Answer

Hello Bob,

The "SUDS" error can be caused by too much detergent, improper detergent, a drain pump/drain line problem (clogged), or pressure switch malfunction.

1. These washers are designed to use High Efficiency detergent which is formulated for wash tubs that use 5 to 7 gallons of water since it is low sudsing. If you are using the correct detergent, double check the label to make sure it is not double (2X) or triple (3X) concentrated. You could still be placing too much soap in your wash.

To get rid of excessive detergent, place the washer on a RINSE & SPIN cycle with one tablespoon of corn oil or vegetable oil to kill the suds, and run it through a normal wash cycle with white vinegar to flush the vegetable oil from the unit.

2. If you do not have a detergent issue, double check the drain pump and drain lines to ensure they are not obstructed in any way.

Obstructions in the drain pump and/or drain lines can attribute to air getting trapped in the drain pump and cause the error code. Double check all electrical connections to the drain pump and Central Control Unit (CCU). You will need to remove the top panel of the washer to access the CCU. This is accomplished by removing the three screws in the back of the washer that hold the top panel in place. With the screws removed, slide the panel back, then off. The CCU is located directly behind the wash tub in the center of the washer.

Read More...

Answered by AppliancePartsPros.com   |   Tuesday, October 9, 2012

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro

Share your thoughts with other customers

Answer or comment
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google