Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Control Board by Whirlpool

4.89 (64)
By: Whirlpool
Part Number: OEM18019011
Manufacturer Part Number: WP22002989

This is a Whirlpool washer control board. This is the main control board behind the user interface, not to be confused with the motor control board located within the body of the washer. This part controls the main functions of the washer and toggles between different cycles. Certain functions may become unavailable intermittently when the main control board loses function. The washer may also continue to spin, not following the regular timeline of the cycle.Start the repair by pulling the control knob from the front of the washer. Pull the washer out from the wall to access the rear panel. Remove the screws from the back panel, and push back on the control panel while sliding a flat head under the right corner to release the mounting clip. Repeat this on the left side, and the central console should pull free. Release the clips for the wire harness and remove the air hose from the control board. Remove the mounting screws and pull the control board from its protective console. Reverse this process to install the new component.This product is a genuine OEM part sourced directly from the manufacturer. This part is compatible with Whirlpool, Maytag, and JennAir appliances.

More

Questions & Answers

For Whirlpool Washer Control Board (Part Number: OEM18019011)

View all Questions

Answer

Craig, The next check should be at the fill hoses and valve. If you haven't yet, check and clean the debris screens in the fill hose and inside the fill valve inlets. Then test the water level switch circuits WP22002921 or 22002994 (depending on serial number) with the air tube disconnected. You would also want to blow in the end of the hose, this will clear any debris or sediment in the tube. If the control board doesn't see a change in the switch circuits on the pressure switch within a specific time, the control "assumes" the washer is flooding and shuts down. Also a resistance test is not as accurate as needed, you can get a proper resistance value, and the solenoid not lift the plunger in the valve body, and this washer is temperature controlled, it fluctuates the valves off and on the maintain a minimum water temperature, if there's a failed solenoid plunger, when the control cycles the power to the other solenoid, if it doesn't lift the washer will stop filling and then shut down after a few minutes. Yes, you can test all the components within this washer with a digital multi meter.
Using the wiring diagram and test information on the tech data sheet in the console, you shouldn't have any issues.

Read More...

Answered by AppliancePartsPros.com   |   Wednesday, September 11, 2013

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro

Share your thoughts with other customers

Answer or comment
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google