John for Model Number awh4000aw washer overfilling. found burnt spots on back of control board. (just followed smell) are there other parts that could be bad that caused this and will that burn new $200 control board. Fill switch is ok kicked off fill at 5 gal and secondary at 6 gal. I am worried about timer, it sounds funny. John
Answer John, We believe you have a MAH4000AWW "Neptune" washer. The burnt tracers are probably on or in the right hand bottom corner of the backside of the control board. These tracers are the circuit to the fill valve, when they short out they usually keep the fill valve solenoid activated and cause the washer to overfill. You'll also want to check the fill valve solenoids and wiring, (especially the green ground wire)or replace the fill valve WP22002795 and replace the control board. The timers can become noisy after a few years of service, but they seldom fail, as long as it is operating/advancing you'll be OK. Read More... Answered by AppliancePartsPros.com | Monday, December 23, 2013