Joville for Model Number MAH4000AWW This was my post; My timer would not move through the cycles, so I put a new timer on, still have the same problem. I was always able to move the timer manually (old/new) and all functions would work wash/rinse/spin however it just will not work automatically through the various cycles. What can you suggest may be the problem? Thanks. John Read more: http://www.appliancepartspros.com/questions-for-WHIRLPOOL-Board--control-AP4026827-qid17527.aspx#q17527#ixzz1TE6BrzfY http://www.appliancepartspros.com This post was just below the post you answered (my name was John)
Answer Hi Joville. Is Your pump clear? Is the drain pipe or the drain hose clear? This will stop the pressure switch from being satisfied and stop the machine. You will need to remove the front door and front panel . Then on the right front of the base is the motor control board. There should be a white or clear plastic cover with a 5/16" screw holding it down. Remove the cover and check to see if the black Transistors are not blown off the face of the board. This is a 3 phase electronic control board that gives you the high speed spin.This part # is 12002039 IF YOU HAVE SERIES 88" or before this will be the part you will need . It comes with the board and the new designed motor. Thank you. Read More... Answered by AppliancePartsPros.com | Tuesday, July 26, 2011