Richard for Model Number WFW8410SW02 I have a front load model WFW8410SW02 washer. sometimes the washer will not go through the entire process. It is sporadic, it may run for 10 minutes then turn off. Other times it will not use the softener, and will shut down. I have changed the control box twice and it still does this. The last time I had a problem it was the hose going to the pressure switch and I replaced it. Any thought as to why this machine would be doing this?
Answer Richard, First, disconnect the fill hoses from the faucets, flush the water supply pipes, remove and clean the screened hose washers in the end of the fill hoses and then remove the filter screens in the fill valve and clean them. A slow fill cycle could cause the washer control to shut down, but will usually cause and error code. If you remove the lower access panel, you should find the tech data sheet attached to the inside in a plastic bag. You can program the control to review the error codes logged in the memory, and the control can run an operational test and give you an idea of where to start the diagnosis. Read More... Answered by AppliancePartsPros.com | Tuesday, March 1, 2016