Customer Questions and Answers for Dishwasher Electronic Control Board by Whirlpool

Henry, We wouldn't expect the LED lights or touchpad to create an issue with the flickering kitchen light(s). These are both low DC voltage circuits. But, you will need to replace the control panel/keypad assembly WPW10481125. This is where the issue is for the dim display lights and no programming when a selection is made. Resetting the breaker doesn't necessarily clear or reset the control board. " To invoke the Diagnostics Cycle, perform the following while in standby: ¦ Press any 3 keys in the sequence 1-2-3-1-2-3- 1-2-3 with no more than 1 second between key presses ¦ The Service Diagnostics Cycle will start when the door is closed. ¦ To rapid advance 1 interval at a time, press the Start/Resume key. Rapid advancing may skip sensor checks as some checks require 2 complete intervals." You'll want to check and make sure the wiring connections in the junction box on the front frame, behind the kickplate/lower access panel are tight and properly wrapped together. If the flickering lights persist, you'll need an electrician to check the circuit voltage and amperage draw, and repair the issue.