Tim K for Model Number KUSD Model KUDS01FLSS2. User Interface Panel (UIP) lights are not illuminated, washer does not work at all. Previously replaced UIP board because of water corrosion issue and failure. Washer worked for several months until total failure with UIP lights no longer illuminated. Suspected Electronic Control Assembly failure due to water corrosion because it is located immediately below the UIP and it appeared to have same corrosion. Removed and replaced Electronic Control Assembly AP3775964 (8564542). Verified power to fuse on Electronic Control Assembly unit is 120 volts. Unit appears to be fully hot, but User Interface panel lights are still not illuminated. Have not yet performed voltage level troubleshooting on each electrical component. Any suggestions before I begin this process?
Answer Hello Tim. It sounds like the fuse 8193762 is bad and will need to be replaced. Remove the fuse from the unit and test it for continuity. If it is open, replace th fuse and the wires. Hope this helps. Read More... Answered by AppliancePartsPros.com | Wednesday, November 23, 2011