Lawrence Ramirez for Model Number kenmore dishwasher 665 13842k601 Problem is no power. Reset main board by alternately pressing "sani rinse" and "heated dry" twice. All lights light up then "normal wash" and "washing" lights then "Quick rinse" and "drying" lights. Machine seems to run. This logic occurs twice then machine shuts off after several minutes.
Answer Lawrence, You pressed the wrong keys " To invoke the Diagnostics Cycle, perform the following key presses or actions in less than 6 seconds while in standby: Heated Dry ? Normal ? Heated Dry ? Normal . (To rapid advance one interval at a time, press the Start/Resume key). Invoking Service Diagnostics clears all status and last ran information from memory and restores defaults; It also forces the next cycle to be a sensor calibration cycle." If there is an issue with the control, certain lights will flash, at the end of the test mode. If there are no flashing LED lights at the end of the test mode, replace the control panel / key pad assembly. Read More... Answered by AppliancePartsPros.com | Wednesday, November 1, 2017