Corey for Model Number 66513129K703 kemore elite dishwasher Hello, My dishwasher tries to start then stops and gives the 6-1 code. The valve seems to start but then stops immediately. I've replaced the inlet valve and the same thing happens. I've tested the float switch by jumping the 2 wires together and is a no go. Next I made sure the drain hose was clear and poured water in the base and started the drain cycle and it worked fine. I've also ran the diagnostic test which ran successfully it seems. Any advice would be appreciated. I've also taken a look at the control board to make sure all the connections were secure. thanks again corey
Answer Corey, With the valve not getting voltage to it then this would most likely be caused by a faulty main control board on the unit. Read More... Answered by AppliancePartsPros.com | Tuesday, September 18, 2018