Art L for Model Number MDBH969aws5 Clean light was doing the 7 flash. I put it in diagnostics mode then cleared the code. The dishwasher fills, the heating element gets hot, water does not fill to the heating element, just below, not sure if its suppose to. It sounds like it goes into wash mode and pumps sprays water for second then stops sits for minutes then drains. Water is not being sprayed inside the washer top or bottom. Washer is just over a year old. Could it be the control board??
Answer Art, The clean light flashing 7 times is a indication of a heating circuit failure. Since the code reset and the unit went into operation then the issue would most likely be caused by a faulty control board especially with the heater now working. You will want to check the wiring harness as well. Read More... Answered by AppliancePartsPros.com | Thursday, January 2, 2014