Ron for Model Number Maytag Dryer LDE412 series07 Your video shows a very simple access method which would be great as I am anticipating some internal part replacements from a noise I have begun to hear from the rear of my dryer. However, the SN for my ancient dryer is 226869XG, apparently built in 1989. This dryer does not have a front panel like the one shown in your repair videos. Is it possible to remove the front of this ancient model for easy access to the innards that i need to change?
Answer Hello Ron, To remove the front of this design, remove the two screws 204439 from the front panel located about 4 to 6 inches from the floor, threaded in at an upward angle. The bottom of the front panel will then pivot upward and the top will un-clip from the top. This will enable you to remove the door switch wires and set the main front aside and remove the screws retaining the front bulkhead. The belt and drum can then be removed for access to the internal components. Re-assemble in the reverse order. Read More... Answered by AppliancePartsPros.com | Friday, January 8, 2016