Paul for Model Number 665.15784300 I just replaced the seals then the entire pump/motor assembly. The unit worked like new for exactly one time. Now the "lock on" light stays on and can't be reset. Could the new pump be defective a cause a short in the controller board?I see the cost for the controller just went up about $30. If I replace this , I will be approaching the cost for a new unit! Please help!
Answer Hello Paul. Check and make sure there are no loose connections and the ribbon cable is seated properly. If so, and the control panel is good, it sounds like the control assembly WP8530929 is bad and will need to be replaced. Hope this helps. Read More... Answered by AppliancePartsPros.com | Wednesday, October 5, 2011