Customer Questions and Answers for Oven Igniter by Whirlpool

Craig, If there are no issues with the top burners, you'll need to concentrate on the DSI spark module circuit(s) WPW10331686, and the oven gas distribution valve WPW10293048. Here's some help. " First thing, check and make sure the power cord is attached to a properly polarized and grounded 120 VAC outlet. A proper ground is very important for the range to operate properly. Then you'll need to make several tests at the gas distribution valve. You'll need a multi meter to test voltage and resistances. At the valve body terminals, with the wires labeled and removed from the middle terminal to each of the outer terminals, you should read 215 ohms resistance. With the wires reconnected, when you select the bake cycle, you should have a reading of 8 to 18 VDC across the red and orange wires. When you make a broil selection you should have the same 8 to 18 VDC,across the orange and blue wires." If all's OK, check the end of the igniter for damage or distortion Check and clean the venturi openings across the burner the bottom of the burner tube, and replace the DSI spark module.