Greg for Model Number mdb7609awb2 well the dishwasher stopped working and the clean light was flashing so upon further inspection found that the burner was burned through near the point of insertion in the tub so i ordered a new burner installed it and the clean light still blinks and the dishwasher still does not work by the way the clean light is yellow in color and blinks 7 times. any answers thank you
Answer Greg, You still have an issue in the heater circuit. " PROBLEM: Stopped Running, Will Not Start and Clean LED Blinks 7 Times, then Repeats (Water Heating Fault). Control is programmed to stop running and not allow any further cycles if it detects a water heating problem (no temperature increase detected in heated Main Wash on 3 consecutive cycles). Control blinks the Clean LED 7 times repeatedly and disables the Start/Resume key until cleared. Heater circuit problem: Open in heater. Open connection or component in heater circuit. Faulty heater drive circuit on control. Try resetting the control first : NOTE 1. To invoke the Diagnostics Cycle, perform the following key presses or actions in less than 6 sec. while in standby: Heated Dry ? Normal ? Heated Dry ? Normal . Allow the control to advance through the complete test mode, to OFF. Then check for proper program and operation. Thanks and Good Luck Read More... Answered by AppliancePartsPros.com | Monday, November 21, 2011