Bruce for Model Number 665.1746930 I recently purchased a heating element and board (AP3841139) for my dishwasher and installed it per the directions. It worked for one cycle and the thermal fuse blew. I purchased a new fuse and wiring harness from a local dealer ( p/n 8193762 ) which also blew upon the second cycle. I installed the thermal shield as directed and am at a loss. I also noticed that the wash delay feature (2/4/6 hr) now illuminates all lights on the display before the fuse blew. I would like to know what the amp rating is on this fuse and if there might be slightly higher unit available. In my opinion, the higher temp dry time cannot be handled by the stock fuse and the upgraded wiring harness. Have you encountered this problem elsewhere?
Answer Hello Bruce. When you replaced the fuse, did you cut and splice in the new wires sent with the new fuse? If not, this has to be done, or the unit will keep blowing the fuse 8193762. Hope this helps. Read More... Answered by AppliancePartsPros.com | Thursday, May 19, 2011