Customer Questions and Answers for Spark Module by Whirlpool

Hello Tom! The spark module WPW10331686 will come with step by step instructions regarding the installation of this part. Here is the information off the installation sheet:
1. Unplug range or disconnect power.
2. A red wire used with the original electronic board will
need to be removed and taped off. This red wire is not
required when installing the replacement board. See
Figure 1.
3. A jumper located at the power cord connection must
also be removed. (This connection is located at the
right rear area of the storage drawer/warming drawer
compartment). See Figure 2.
NOTE: On ranges with a warming drawer the rear
screws on the RIGHT SIDE panel will have to be
removed to gain access to the 120V connector plug
and transformer wiring connector.
Once the jumper is removed, reconnect the power cord
connection. See Figure 3 and 4.
**Please not the figures are only available with the tech installation sheet.
Hope this information helps you determine if you can repair your unit. Thanks!