Muhammad A. for Model Number Kenmore Washer 110.28832700 The washer runs for 10 seconds and then it trips. I have to unplug it for a few minutes to rest and then it does the same thing. I noticed that the power cord gets hot when it stops. After I reset it again and turn the dial to spin then it spins and drains the water fine. I have replaced the clutch and coupler. I have checked the lid switch and it is good. I appreciate your response
Answer Hello Muhammad, Need to bypass the lid switch and unplug the motor connector. Set to spin and turn on with the motor wiring connector unplugged. Check for 120Vac to more than one terminal on the motor connector at the same time. There should only be 120Vac on one terminal. More than one terminal energized indicates another issue that will have to be troubleshot with a test meter. There are several things that can cause this including a bad timer, motor, fabric selector switch, and/or wiring harness. An experienced technician may need to troubleshoot to determine the exact cause so parts will not be replaced arbitrarily. Read More... Answered by AppliancePartsPros.com | Tuesday, July 5, 2022