Cat for Model Number JDR8895AAS Hello, Our bottom oven is basically not preheating. I'll set the temp to 350* and an hour later it's still at 195* We get no messages or error codes. We just replaced the clock switch unit for other issues that did get resolved but this had no effect on the lower oven. I'm guessing it's this temp sensor and would like to order it right away but I would like to be sure and also know if we should order any other parts to make this heat up again? Also, while I'm here... In the past it seems that the whole unit go haywire when we use both the top and bottom ovens. The clock goes blank, starts to blink and a little red dot starts blinking. But we get no error messages. Both ovens turn off and we have to wait a bit before using either one again. Any suggestions? Thank you for your time.
Answer Cat, based on your post, the most likely issue is the lower oven bake element WP7406P428-60, check and make sure there are no brokrn or cracked areas on the element and no loose connections. Re check and make sure you did not cross any wires at the new control, when you replaced it. That could be part of the issue with the control. If all's OK and the issue still remains, then replace the control again. Read More... Answered by AppliancePartsPros.com | Friday, September 21, 2012