Mudit for Model Number Whirlpool Washer Model #LSR8010PQ1 Greatly impressed by this site after I found it today for the first time! My washer (Top Load Whirlpool)will finish the wash cycles, leaving ~half gallon of water behind, so cloths are damp and soaking before moving to Dryer. Washer seems to be washing clothes, saw rotation of agitator etc and when tested for extra spin etc, I saw water pour and then draining as usual, except still leaving some water in bottom of drum. Following video instructions, I decided to open the unit with plans to replace Washer Pump (1) I opened the washer unit and removed the pump part(#AP2907492) as I was told to replace. I was not sure if Pump needed replaced as it seems to be working in my opinion. Lot of water came out when I checked both tub and drain hoses, but nothing stuck there. Moving drum by hand caused more water to come out, I thought this as normal. (2) I thought there was something stuck (e.g. a sock) unerneather Agitator Base unit as the agitator base was NOT moving and seem stuck. The top part, Move Agit was turning as normal. So I removed Mover Agit and agitator base unit (AP2906554) by removing the bolt and pulling the whole unit out, just like in video. Found nothing stuck under the agitator. (3) I have opened the whole Washer unit following video instrcutions and need to know what part to replace and fix. Is it the pump (AP2907492), the clutch assembly (AP3094537) or some thing else. PLEASE HELP. I can test anything since the unit is open. What could be my problem and how do I fix it?? Thanks MUCH.
Answer Hello Mudit. If the water is shutting off, and the hoses are clear, then it sounds like the pump WP3363394 is not working properly and will need to be replaced. Hope this helps. Read More... Answered by AppliancePartsPros.com | Thursday, December 29, 2011