Customer Questions and Answers for Washer Drain Pump by Whirlpool

Jeff, the part number you supplied is not for the model number you supplied. You will need 27001233 for that particular model number. Here's some help" 1. Remove service access panel, NOTE: There will always be some water that will remain in outer tub, before removing hoses from pump, hoses must be pinched off or drained to prevent water spillage. 2. Loosen hose clamps and remove hoses from pump assembly. 3. Unhook idler spring from clip on front of the motor mounting bracket.NOTE: Use care when releasing idler lever tension. If idler spring is overstretched, washer operation will be affected. 4. Reach in and around left side of motor and remove belt off large drive pulley. 5. Disconnect wire harness from motor switch by pressing down on locking tab on top of connection block and at the same time, pull connection block away from motor switch.6. Remove bolts securing motor and mounting bracket to lower outer tub flange and to weldment assembly.7. Lift complete assembly out of washer. NOTE: Lay motor on its side. Observe belt configuration around rear pump leg. Belt MUST encircle rear pump leg when reassembling. 8. Reverse procedure to reassemble.Pump and Belt Removal 1. Remove motor, see “Motor and Mounting Bracket” procedure.2. Remove screws securing pump assembly to motor.1. Remove any corrosion or foreign material from motor shaft. 2. Apply a thin film of lubricant to the end and sides of motor shaft.NOTE: This lubricant helps keep moisture out of the hub area and prevents corrosion. 3. Align belt on motor pulley and tension pulley." You'll need a variety of basic hand tools and a mechanis "SAE" socket and wrench set. Good Luck and Thanks