Jimmy for Model Number mdbh965aww The answer to a question by Jim about some lights coming on but cycle not starting and lights go off after several seconds is my problem but I was wondering if there is a way I can verify that I do not need a board control. Your answer to him was he may need control panel. Also in my vent there is a small plastic part that has a pencil lead sized rod that may be broken off up inside the female side. Do you know where I can find detail schematic for that kind of part with that much detail? I am not a pro obviously but I am familiar with ohm meters I used to install alarm/ intercoms/ low voltage stuff. I hope I can figure this out for myself with your help. Thanks very much.
Answer Hello Jimmy! If you are pressing the options on the control panel and it is not sending a signal to the control board 12002709, the control panel 6-919836 itself will need to be replaced. You can test the parts with a multimeter MA-DM1. Here is a link from our free repair forum you can refer to for help with using a multi meter. Hope this helps, thaks! http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More... Answered by AppliancePartsPros.com | Tuesday, May 24, 2011