Pam for Model Number MTW5740TQ0 My Maytag washer leaked a lot of water. When I went to check to see if finished I had water (a lot) all over my floor. The cycle did finish. After cleaning up all the water. I tried to wash another load of clothes; but no water was coming into the machine. I checked both ends of both water hoses for debris and both were clear. I tried to move the cycle knob around to try to see if that would work; nothing. The machine will go through a full cycle; spinning and agitated but still no water. A friend looked at my washer and thinks it is the water level switch because he fells the machine thinks it already has water in in even though it doesn't and by doing some research I'm finding it can be the water valve. I cannot afford to change a bunch of parts. I want to make sure the right part is changed and the machine does not leak again and of course fills up with water. Please advise..
Answer Hello Pam. You will need to test and see if there is power going to the water valve WP3979346. If so, and the valve does not bring in water, you will need to replace the water valve. Also check the pressure hose and make sure it is not clogged. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More... Answered by AppliancePartsPros.com | Saturday, September 17, 2011