Antonio September 22, 2014 for Model Number WTW5800SW0 Washing Machine will not fill with water. When I pull it out to start the wash to fill with water it will start the wash cycle and go thought all the cycles but no water.
1 Answer Hello Antonio. You will need to replace the pressure switch W10339250 based on the information you provided. Read More...
1 Answer Hello Tony. Check the water valve first for power. Make sure the screens are not clogged. If there is power there and it does not fill, replace the valve. Read More...
Nathan February 10, 2014 for Model Number MTW5740T0Q When my washer starts filling up it reaches a certain level and stops filling even though the water is running in. it has to start pumping it out at the same time it is running in or it would overflow. I can turn the level switch down about middle ways and it will stop running and start washing. It will do the same thing when it goes to rinse. I never have to mess with anything but the level sensor, could this be my problem?
1 Answer Hello Nathan. Yes, based on the information you provided, you need to order and replace the water level switch on the unit. Read More...
Keith February 10, 2012 for Model Number wtw5820swd Machine fills sometimes, but will not start to wash on any cycle. Can us rinse and will fill. jumped out fill switch still wont work.
1 Answer Hello Keith. You will need to check and see if the lid switch WP8318084 is bad on the unit. If the lid switch is bad, it will cause the unit not to run. Hope this helps. Read More...
Pam September 16, 2011 for Model Number MTW5740TQ0 My Maytag washer leaked a lot of water. When I went to check to see if finished I had water (a lot) all over my floor. The cycle did finish. After cleaning up all the water. I tried to wash another load of clothes; but no water was coming into the machine. I checked both ends of both water hoses for debris and both were clear. I tried to move the cycle knob around to try to see if that would work; nothing. The machine will go through a full cycle; spinning and agitated but still no water. A friend looked at my washer and thinks it is the water level switch because he fells the machine thinks it already has water in in even though it doesn't and by doing some research I'm finding it can be the water valve. I cannot afford to change a bunch of parts. I want to make sure the right part is changed and the machine does not leak again and of course fills up with water. Please advise..
1 Answer Hello Pam. You will need to test and see if there is power going to the water valve WP3979346. If so, and the valve does not bring in water, you will need to replace the water valve. Also check the pressure hose and make sure it is not clogged. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...