Keith for Model Number WFW8300SW04 I just hooked up this washer after transporting from one house to another and a year of storage. Ran a wash cycle, seemed to work fine (water level, agitation, etc.) When going to spin, would not spin, just stopped and shut down. No error codes. Unplugged, plugged back in, tried a drain and spin cycle, pumped out, would not spin, just shut down. Any thoughts?
Answer Hello Keith,you say no error codes, was this during the wash cycle or in the diagnostic test? To run the test and retrieve any codes ,with washer empty, close the door and press any keypad,except pause /cancel , hold in for 4 seconds /release 4 seconds do this 4x , washer will display any fault codes, press same key once for any additional codes, if no more codes washer will start an automatic test cycle, Read More... Answered by AppliancePartsPros.com | Monday, September 9, 2019