Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Water Level Pressure Switch by Whirlpool

4.89 (64)
By: Whirlpool
Part Number: OEM20943129
Manufacturer Part Number: W11417619

This water level pressure switch senses air pressure from the tub and signals the control to stop filling at the correct level. Replacing a weak or failed switch restores proper filling, helps prevent over/underfilling, and allows cycles to advance.

  • Monitors tub water level via the pressure hose and sends the level signal to the control
  • Stops water flow at the target level so wash, rinse, and spin can begin
  • Common symptoms of a failing switch: continuous filling, overfilling or underfilling, cycle won't advance past fill/sensing, or stops with water still in the tub
  • A cracked, kinked, or blocked pressure hose can mimic switch failure—inspect during diagnosis
What's included: 1 water level pressure switch Install notes:
  • Disconnect power and turn off water supply before servicing
  • Access the switch from the console/top or rear panel per your model; note wire orientation
  • Transfer and firmly seat the pressure hose; inspect it for kinks, cracks, or blockages and replace if damaged
  • After installation, run a fill test; some models may require a diagnostic calibration—see the tech sheet or user manual

More

Questions & Answers

For Whirlpool Water Level Pressure Switch (Part Number: OEM20943129)

View all Questions

Dan B for Model Number WFW8400TW03

Whirlpool Duet Sport WFW8400TW03 front loader washer. Getting F20 error code.Things I've done. 1) checked hot/cold fill hoses, good water pressure, no clogs, inlet value screens appear clear 2) checked water pressure switch, checked continuity per manual, ok 3) blew into water pressure switch, heard 2 clicks, ok 4) blew into water pressure hose, could hear bubbles and air going through 5) Tried Hot cycle, then cold cycle, got F20 on both, usually washer fills up with water ok and then get F20 code, sometimes, looks like it goes through wash cycle and then F20. 6) Don't see any kinks in hoses interal or external, looks like all electrial connectors are connected.

Answer

Hello Dan,

You will also want to check to make sure that the drain pump is operating. Make sure that there is not a siphoning effect happening where the water just flows back out of unit. Press Pause/Cancel to clear display and the unit will drain for 3 minutes. Verify that the harness connections to valves, pressure switch and control board are good. Check for leaks from hoses. Check the hose attached to bottom of tub to make sure that there is nothing clogged in it not allow water to drain properly.

Read More...

Answered by AppliancePartsPros.com   |   Monday, December 24, 2012

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro

Share your thoughts with other customers

Answer or comment
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google