Terry H. for Model Number WED5200VQ1 Element wont heat, timer won't advance in any cycle. I have 220Vac when go across leads bk and red into timer. I have 120 volts on disconnected red wire far right before element. This wire goes back into bottom of dryer. No voltage on other red wire that feeds back to thermostats. I have replaced heating element, 2 thermostats on element cover, and non resettable fuse and operating thermostat near the blower. The timer will turn and turn off motor when physically done. I know the motor runs. I know I have 220 volts into unit from plug and all fuses in back are good. I also have 220Vac going into heating knob. I can't prove if timer bad or if have another issue.
Answer Hello Terry, If there are no harness issues, the problem will most likely be a set of contacts in the timer. The wire in the bottom of the dryer, I am assuming, is the one going to the dryer motor and voltage being on it would verify the centrifugal switches' proper operation. Read More... Answered by AppliancePartsPros.com | Monday, September 1, 2014