Grady K. for Model Number LAT 8824 AAE, Maytag washer How hard is it to replace the timer (Part # AP4026151) and how would I do it? Thanks, Grady.
Answer Hello Grady! Here are the instructions regarding the timer WP22001024 removal. You will install in the reverse order. Hope this information helps you! Timer Removal: 1. Disconnect washer from power supply. 2. Pry the cap off and pull the retainer clip off the timer shaft. Remove the timer knob, spring and dial. NOTE: The timer shaft pin is longer on one side. This is to prevent the dial from being installed incorrectly. 3. Remove the two screws holding the timer in postion. *Note which set of holes the mounting screws are located in. 4. Remove the two inside screws on the control panel and tilt away from the console. 5. Remove wires from timer. NOTE: Always replace by wire number. Read More... Answered by AppliancePartsPros.com | Monday, June 27, 2011